Ultrasonic mist maker

Ultrasonic mist maker dispersed the water substructure produced fog nature and elegantly from high-frequency 

oscillation in atomization piece. No need any chemical agent.

 Popular usage

Common fault & treatment：

Troubles	Analysis	Treatment
No electricity in atomizer,no indicator light	1. power supply abornomal from atomizer. 2.The polarity of the power supply is reversed	1.Check the plug is good, check the  power supply is good. 2.exchange the polarity of the power  supply is OK.
Normal power supply also power light is  on but no moisture.	water level of container is too low.	preapre enough water
Some nozzle cannot working	atomizer film damaged	replace the film
	nozzle circuit damaged	back to supplier for repair.
small spray from nozzle	old film or damage	replace the  new film
The coating can be move from surface  of mist maker	the liquid humidifying is corrosion	change the liquid
	many mist maker placed in same container  and not connected.	Connected all mist maker

Application Notice

1. Please choose DC46±2V, Rate: >300W.
2. Ring transformer must have alumimum heat sink,and prepare some thermal grease between rectifier bridge and alumimum heat sink.
3. more than one mist maker fixed in same tank,please conducted each other.
4. The fog produced from mist maker must remove by fan. Keep each mist maker have 600cm2 space. High temprature water will 

shorten life of mist maker.
5. Mist maker loved neutral liquid (PH5~8). Acid can corrosion shell & film,alkaline liquid can effect fog, shorten the life of mist maker & film.
6. Do not damage water level switch in install, the water level switch will out of order if damaged.
7. Do not put the hand over the mist maker when working.
8. Do not let mist maker working out of water, please put the mist maker in water before power on.

Maintenace for mist maker

For your products long life and good effect, please read below insruction:
1.The mineral will build up on the shell or film after a long time service. It will effect the long life & fog.

 We advise that you had better clean the mist maker each half an month. You can use soft cloth with alcohol.

 Do not use any hard cloth for scrath mist maker or film.

2.Water quality will effect the long life of mist maker. We advise you that used clean water.
3.After long time service (3000 hours),the film life will be shorten, the atomiztion will less. Like this,

 please replace the film.
Replace film as follows:
Power off first. Take out the atomizer from water and upside down the mist maker. When the water come out

 from mist maker, use dry cloth clean the mist maker.Use tool open the end ring and take out the film and put

 in the new film.