10 head ultrasonic mist maker  

1.up and down vibration 1700KHZ, atomizer film will produced fog.
2. The max temp control is 55±3 or it will stop working.
3. The column is a capacitor,if your water quality is good, please choose stainless steel column mist maker, the stainless steel column will automatic sensor in high capacitor. If the water has much limescale, the limescale can round the column, the mist maker cannot working.
4. If mist maker run out of water, it can be damaged. It is belong dry running.
5. When mist maker working, The temperature of water will be rised. 1PCS can rise 3℃, 2PCS can rise 4℃,3PCS will rise 5℃, if 20PCS running together, we must consider heat dissipation.

Products feature:

Item：A10D48-001                                                             fog amount：7KG/H

work voltage：40~50V                                                        work current:5300~5700MA

work temperature:5~55℃                                                    best water level:36~40mm

Humidity method:Spray moisture                                        Timing function:No provided

Protection in short water:provided                                        material:copper shell

machinery combination:power switch/tansformer                 warranty:2 years

The advantage of Runyang Mist maker:
1. When mist maker is running, temperature is rising, current is decreasing, Prevent the circuit boards from burning when temprature is rising.
2.It must have 3 test before shipping out, and have  PCB Assembly test, finished products test, leaking test.
3. The height of PCB about 1.5mm, more 1.2mm height than other same suppliers.
4.There is Explosion-proof fuse on each mist vent, It has the function of heat dissipation and combustion.
5. Triode used in PCB, it is better than diode.

Mist maker working photgo

1. Please choose DC46±2V, Rate: >300W.
2. Ring transformer must have alumimum heat sink,and prepare some thermal grease between rectifier bridge and alumimum heat sink.
3. more than one mist maker fixed in same tank,please conducted each other.
4. The fog produced from mist maker must remove by fan. Keep each mist maker have 600cm2 space. High temprature water will shorten life of mist maker.
5. Mist maker loved neutral liquid (PH5~8). Acid can corrosion shell & film,alkaline liquid can effect fog, shorten the life of mist maker & film.
6. Do not damage water level switch in install, the water level switch will out of order if damaged.
7. Do not put the hand over the mist maker when working.
8. Do not let mist maker working out of water, please put the mist maker in water before power on.
9. Please turn off the power before take out the mist maker from water.

Maintenace for mist maker

For your products long life and good effect, please read below insruction:
1.The mineral will build up on the shell or film after a long time service. It will effect the long life & fog. We advise that you had better clean the mist maker each half an month. You can use soft cloth with alcohol. Do not use any hard cloth for scrath mist maker or film.
2.Water quality will effect the long life of mist maker. We advise you that used clean water.
3.After long time service (3000 hours),the film life will be shorten, the atomiztion will less. Like this, please replace the film.
Replace film as follows:
Power off first. Take out the atomizer from water and upside down the mist maker. When the water come out from mist maker, use dry cloth clean the mist maker.Use tool open the end ring and take out the film and put in the new film.